Boss 12 Cabinet

Post Reply
pss
Forum Czar
Posts: 862
Joined: Mon Jul 24, 2017 8:40 am
My RE system: 8330 watts in three strings, Flexmax 60 x 3, Radian 8048A, GSLC load center, Mate 3S, Hub 10.3, FN-DC and 900 Amp, 48V Trojan T105-RE battery bank.

Boss 12 Cabinet

Post by pss »

Has anyone had any experience yet with using a Simpliphi Boss 12 cabinet? I need something tat can be outdoors in a covered area and meets UL9450 certification. Any info appreciated.
raysun
Forum Emperor
Posts: 5622
Joined: Tue Jul 26, 2016 5:57 am
My RE system: Flexpower Two: (2) FXR3048A-01, (2) FM80, MATE3s, FlexNetDC
SimpliPhi 48-3.8 (6 @ 48v)
Outback IBR3 battery enclosure
REC Alpha 440W panels - 2 arrays: each of 4 strings of 2 in series
Honda EU7000is gas fuel generator

Re: Boss 12 Cabinet

Post by raysun »

No experience with the cabinet, but I used similar cabling scheme - the SimpliPhi Bus Bar and one cable per shelf to a parallel bus that connects all shelves.

In this arrangement, according to Phi tech support, battery blocks must be added (and removed) in sets of 3 (one entire battery bus bar at a time.)
pss
Forum Czar
Posts: 862
Joined: Mon Jul 24, 2017 8:40 am
My RE system: 8330 watts in three strings, Flexmax 60 x 3, Radian 8048A, GSLC load center, Mate 3S, Hub 10.3, FN-DC and 900 Amp, 48V Trojan T105-RE battery bank.

Re: Boss 12 Cabinet

Post by pss »

I read the manual and watched the video. Turned some steel and strut into an expensive cabinet. Paying a lot for UL certificate. But no choice. Any other options would be nice.
Post Reply