Looking for a panel to serve as a disconnect

Discussion about the Power System PV Combiner (PSPV)

Moderators: OutBack, OutBack Moderator Team

Post Reply
josephguidry
Forum Junior Member
Posts: 1
Joined: Tue Aug 24, 2021 10:41 pm

Looking for a panel to serve as a disconnect

Post by josephguidry »

Hi guys, I'm a newbie. I am using 4 Kyocera, KC-120s, and looking for a panel to serve as a disconnect for my solar panels and my MX 60. My battery array is a 12-volt array. But I know space will be limited. I know I can get an at-type fuse that will handle the amps, but I would prefer to use a breaker.
Do you have any recommendations for a suitable console?
User avatar
Mike Curran
Forum Emperor
Posts: 2477
Joined: Sat Aug 28, 2004 6:28 pm
My RE system: Outback - Garage roof:
- 8 (2x4) Evergreen 180's into one FM80 (2007/2020 - replaced MX60)
- 6 (2×3) ALEO S79-300's into one FM80 (2017)
- 2 grid-tied VFXR3524A-01's series stacked, replaced GVFX's (2020)
- 12 Surrette/Rolls 2V x 1766Ah (2007)
- Hub10.3, Mate3s, FNDC, RTS. Tigo ES maximizers on each PV module.

Westinghouse Solar - Barn roof: (2012)
- 30 (2x15) 235W panels with Enphase M215 microinverters, grid-tied

Outback Skybox - Barn roof: (2019)
- 14 Talesun 275W in series (DC array input to SB inverter/charger)
- 3 SimpliPhi 3.8 batteries, 48V, 225Ah total
- AC coupled input from 14 Talesun 275W, Enphase M215 microinverters

Battery systems operate in grid-tied, battery backup mode
All self-designed and self-installed
Location: Chagrin Falls, Ohio

Re: Looking for a panel to serve as a disconnect

Post by Mike Curran »

I don't use this but could work for you. You'll need to buy a breaker for it, it's large enough to add more panels if you want.
https://www.solar-electric.com/mnpv3.ht ... A8QAvD_BwE
https://smart.tigoenergy.com/p/pZXn7SZQyO45?date=2021-04-19
https://enlighten.enphaseenergy.com/public/systems/Hctc107221
raysun
Forum Emperor
Posts: 5617
Joined: Tue Jul 26, 2016 5:57 am
My RE system: Flexpower Two: (2) FXR3048A-01, (2) FM80, MATE3s, FlexNetDC
SimpliPhi 48-3.8 (6 @ 48v)
Outback IBR3 battery enclosure
REC Alpha 440W panels - 2 arrays: each of 4 strings of 2 in series
Honda EU7000is gas fuel generator

Re: Looking for a panel to serve as a disconnect

Post by raysun »

I use the Midnite Solar combiner box series that Mike recommended. Assuming the 4 Kyocera panels are wired as a single series string, a single disconnect (circuit breaker) is all that's needed.

If there isn't a DC surge suppressor on the PV array circuit, the MNPV combiner is a convenient location to mount one. Midnite Solar sells such a unit.
Post Reply